DF1UD EN

Modes

AM FM SSB CW QRSS AMTOR ATV APRS CLOVER DRM D-STAR HELL PACKET PACTOR PSK31 PSK63 RTTY SAMS SSTV

Go to content

TS-510

Oldtimer

Transceiver Line TS-510


Year of manufacture 1970

  • TS-510 Transmitter-Receiver
  • PS-510 Power Supply and Speaker Unit
  • VFO-5D Remote VFO (Variable Frequency Unit)
  • MC-30 HAM Hand Dynamic Microphone
TS-510 Line


Power Supply PS-510

Transceiver TS-510

VFO-5D


TRIO Allband SSB Transceiver TS-510
SPECIAL FEATURES

  • The TS-510 is a high power, high stability SSB transceiver representative of the SSB era.
  • The Gothic style cabinet design, which gained the admiration of all users of the earlier 500 Series, is employed and will doubtlessly add to the appearance of any shack.
  • The use of an extremely stable VFO, a new development built around 2 FETs and 2 transistors, insures stable QSOs as long as you operate.
  • Accurate, double-gear timing mechanism and linear timing capacitor provide 1 kHz direct reading on all bands.
  • Frequency coverage has been reduced to 25 kHz for one complete rotation of the dial to facilitate tuning in of SSB signals.
  • A high frequency filter especially developed for the 510 Series is employed. Its excellent shape factor makes possible sharp cut-off for both reception and transmission with the TS-5 10.
  • Equipped with a selectivity switch for both SSB and CW modes. Insertion of a CW filter ensures even better CW operation. The CW filter is available as a optional item.
  • The AGC circuit includes an amplifier to insure such high performance that even the largest input signal can be received without distortion. The AGC circuit also features signal strength meter indication independent of RF gain adjustment.
  • Built-in calibration circuit. This circuit is a 25 kHz multi vibrator which permits accurate calibration for every rotation of the dial, such as when making QSYs.
  • Equipped with a sidetone oscillator which eliminates the necessity of adding an AF oscillator for accurate CW operation.
  • Amplifier type ALC. circuit employed has excellent ALC characteristics as compared to those of a grid detector. Ideal SSB signals are produced without sputtering.
  • The ALC voltage can be observed on the meter to monitor operating levels for correct on-the-air operation.
  • Equipped with an RIT circuit which permits fine adjustment during reception and tuner reading correction without changing the main dial setting.
  • The receiver is a dual conversion superheterodyne in which the RF and local oscillator are independently tuned. This, together with the high performance high frequency filter and bandpass filter, provides high stability and sensitivity.
  • AGC time constant can be switched between SLOW and FAST.
  • The use of an external VFO (VFO-5D) in conjunction with the internal VFO permits still more elaborate operation highly regarded by old hands.
  • Many accessory circuits, such as VOX, PTT, amplifier type AGC, RIT, CAL circuits, bandwidth switching, multi meter which indicates Ip, RF, HV, ALC, and signal strength, AGC switch, terminals for external VFO, ALC, and receiver input and output terminals.
  • The power supply is independently and externally connected to the transceiver. The Model PS-510 (containing speaker) power supply unit is also available.

Spezifikation

SPECIFICATIONS
Receive and Transmit Frequencies:

80

meter band

3,50

-

4,00

MHz

40

meter band

7,00

-

7,30

MHz

20

meter band

14,00

-

14,35

MHz

15

meter band

21,00

-

21,45

MHz

10A

meter band

28,00

-

28,50

MHz

10B

meter band

28,52

-

29,70

MHz

10C

meter band

29,12

-

29,70

MHz

           

TYPE OF EMISSION:
SSB (A3J), CW (A1)

RATED INPUT TO FINAL STAGE:
160 W at 3.5 21 MHz
120 W at 28 MHz

ANTENNA INPUT IMPEDANCE:
50 - 75 Ohm

CARRIER SUPPRESSION:
Less than -40dB

SIDE BAND SUPPRESSION:
Less than -40dB

MICROPHONE IMPEDANCE:
50 KOhm (high impedance)

TRANSMIT FREQUENCY CHARACTERISTIC:
300 - 2700Hz ( -6dB)

RADIATION OF UNWANTED COMPONENTS:
Less than -50dB

RECEIVE SENSITIVITY:
0.5KV, S/N ratio of 10 dB at 3.5 - 21 MHz
1.5~V, S/N ratio of 10 dB at 28 MHz

IMAGE RATIO:
More than 50 dB

IF INTERFERENCE:
More than 50 dB

FREQUENCY STABILITY:
within +/- 2 kHz 60 minutes after the power switch
is turned on. Within 100 Hz after 30 minutes.

SELECTIVITY:
SSB:
More than 0.2kHz (at -6dB)
Less than 2.4kHz (at -60dB)
CW:
More than 250Hz (-6dB)
Less than 750 Hz (at -60dB)
Note: Selectivity values in the CW mode applies to a
transceiver with the CW filter used.

AF OUTPUT:
More than 1 watts (with 10% distortion)

RECEIVER OUTPUT IMPEDANCE:
8 Ohm for both speaker and headphones

POWER CONSUMPTION:
315 watts at maximum of transmission
180 watts at maximum of reception
(When the PS-510 is used)

VACUUM TUBES AND TRANSISTORS:
14 vacuum tubes,
2 FETs,
14 transistors, and
30 diodes

DIMENSIONS:
330 (B), 180 (H), 345 (T) mm
(13 W, 7 H, 13 D)

WEIGHT:
9.5 kg (20.9 lbs)

Text is taken from TRIO TS-510 Operating Manual HO5-LB6JM (MX) 1970 manufactured by TRIO ELECTRONICS INC., Tokyo, Japan

Einige Bilder des alten TS-510

[ CLICK ==> ENLARGE ]

Top

DF1UD | General | Station | QSL- Cards | Oldtimer | Homemade | Flea Market | Impressum | Site Map


Sub-Menu:

Last change: Mrz 15 2016
Site erstellt: Sep 01 2001

Back to content | Back to main menu